I sold a very big quantity of those interfaces with 12 months warranty, and i never got a problem with transistors. I know that this model has transistors, but they don't burn. In those interfaces, there is two models of PCB, both are good. Yes it's true that the connector break, but for me a broken connector is better than a broken interface. May put different pcb in same connector box This model have very weak obd16 connector and break very easily, better are with flexible connectorĪlso this model is with transistors and single color ledīut in Chinese the appearance of the product means nothing Or it works just with that cracked chinese sw?įor interfaces with FT232Rl, there is two cases:ġ - if your interface is designed to work with original software, you need only to reprogram Atmega and FTDI eeprom and to use original software ( the version that correspond to your Atmega dump).Ģ - if your chinese interface is designed to work with modified software, you have to reprogram Atmega and FTDI eeprom and Gal (Gal dump is available in other forums) and to desolder some components and to solder some wires (as i explained in a previous post ), you need also a modified software that correspond to your Atmega dump (i posted it in a previous post for 908 version).ĭon't buy Chinese interfaces that work with modified software, they have also other problems, like transistors that burns when we use the interface for a long time or in a car with bad voltage or bad connections. What it is important that if you try to use it after reprogramming this tool with ft232RL inside with original 10.6.0 sw. That's right but it is ept for ftdi and dump for GAL in aminebot tutorial. after plug cable into car, LED shines red and in 2-3 seconds switches to green. I downloaded and repeated all the above operations.įor each version of the program at startup I get the message: Error cable not found = -1 So I got a recommendation from ecutool(china) : please make sure use the software from (908.0 912 10.6.0)Īfter the test I get a message: interface found, Ross-Tech HEX-USB, not plugget into car. I repeated this operation on all programs available on installation disk. Plug the interface to to the car and put the ignition to ON ( not start the engine ) Installed programs, and then repeated these steps:ġ.
I cleaned system from VCDS, drivers, and other.(using ccleaner)
0 kommentar(er)
